LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Seat Back Frame Replacement - Rear No. 1 >> Installation Procedure

Installation Procedure

    Fig 1: Locating Latch Release Cables On Right-Hand Bracket
    GM753544Courtesy of GENERAL MOTORS CORP.
  1. Install the latch release cable to the right-hand hinge bracket.
    2. Fig 2: View Of Latch Release Cable & Head Rest Restraint Cable
    GM753531Courtesy of GENERAL MOTORS CORP.
  2. Install the seat belt retractor assembly, on the left side only. Refer to Seat Belt Retractor Replacement - No. 1 Center Rear .
  3. Install the seat back hinge brackets. Refer to Seat Back Hinge Replacement - Rear No. 1 .
  4. Install the head restraint retractor assembly. Refer to Head Restraint Retractor Assembly Replacement - Rear No. 1 .
  5. Install the latch release assembly. Refer to Seat Back Release Latch Replacement - Rear No. 1 .
  6. Install the latch release cables (1) and the head rest restraint cable (2) to the left-hand hinge bracket.
  7. Install the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Rear No. 1 .
scientia non olet · About LEMON Manuals