LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Rear Seat Replacement >> Removal Procedure

Removal Procedure

  1. Remove the communication interface module if removing the right-hand rear seat. Refer to Communication Interface Module Replacement (TrailBlazer EXT, Envoy XL) or Communication Interface Module Replacement (TrailBlazer, Envoy, Rainier) .
    2. Fig 1: Identifying Seat Latch, Latch Bar & Rear Mounting Nuts
    GM827901Courtesy of GENERAL MOTORS CORP.
  2. Remove the front 2 rear seat mounting nuts (2) securing the seat to the vehicle.
  3. Fold the seat to the stowed position.
  4. Remove the rear 2 rear seat mounting nuts (2) securing the seat to the vehicle.
  5. Remove the seat from the vehicle.
scientia non olet · About LEMON Manuals