LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Mid-Position Floor Latch Assembly Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL) >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Mid-Position Floor Latch Assembly Components
    GM828232Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the mid-position floor latch assembly to the seat cushion frame with the bolts (1).

    Tighten:  Tighten the rear seat mid-position floor latch assembly bolts to 35 N.m (26 lb ft).

  2. Install the cable (3) to the mid-position floor latch assembly (2).
  3. Install the rear center seat belt buckle assembly to the floor latch assembly. Refer to Seat Belt Buckle Replacement - Center Rear .
  4. Install the trim panel to the seat cushion. Refer to Seat Cushion Trim Panel Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL) .
  5. Install the seat in the vehicle. Refer to Rear Seat Replacement .
scientia non olet · About LEMON Manuals