LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Lumbar Support Cable Replacement >> Removal Procedure

Removal Procedure

  1. Remove the seat assembly from the vehicle. Refer to Front Seat Replacement - Bucket .
  2. Remove the seat trim panel. Refer to Seat Cushion Outer Trim Panel Replacement .
  3. Remove the seat back cover and pad. Refer to Front Seat Back Cover and Cushion Pad Replacement .
  4. Pull the cover half-way up the seat back.
    5. Fig 1: View Of Lumbar Cable & Clip
    GM755850Courtesy of GENERAL MOTORS CORP.
  5. Remove the lumbar cable (2) from the cable clip (1) located on the lower seat back.
    6. Fig 2: Locating Lumbar Mechanism
    GM755852Courtesy of GENERAL MOTORS CORP.
  6. Pull the seat back panel and pad away from the frame to expose the lumbar mechanism.
  7. Remove the cable from the lumbar spring.
    8. Fig 3: Identifying Lumbar Mechanism Cable End
    GM755853Courtesy of GENERAL MOTORS CORP.
  8. Unhook the cable end from the lumbar mechanism.
    9. Fig 4: Locating Cable To Seat Adjuster Screws
    GM755848Courtesy of GENERAL MOTORS CORP.
  9. Remove 2 screws (1) securing the cable to the seat adjuster.
scientia non olet · About LEMON Manuals