LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Head Restraint Retractor Assembly Replacement - Rear No. 1 >> Installation Procedure

Installation Procedure

    Fig 1: Aligning Head Restraint Retractor Assembly
    GM753546Courtesy of GENERAL MOTORS CORP.
  1. Position the head restraint retractor assembly to the seat back.
    2. Fig 2: View Of Release Cable In Head Restraint Retractor Assembly Access Hole
    GM753547Courtesy of GENERAL MOTORS CORP.
  2. Install the release cable through the head restraint retractor assembly access hole and sliding the cable retainer into position.
    3. NOTE: Refer to Fastener Notice .
    Fig 3: Identifying Head Restraint Retractor Assembly To Seat Back Frame Bolts
    GM753545Courtesy of GENERAL MOTORS CORP.
  3. Install the 3 bolts that retain the head restraint retractor assembly to the seat back frame.

    Tighten:  Tighten the head restraint retractor bolts to 10 N.m (88 lb in).

  4. Install the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Rear No. 1 .
scientia non olet · About LEMON Manuals