LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Front Seat Replacement - Bucket >> Removal Procedure

Removal Procedure

    CAUTION: Refer to SIR Caution .
  1. Disable SIR. Refer to SIR Disabling and Enabling .
    2. IMPORTANT: Before removing the seat, ensure that the following conditions are met:
    • For power seats, verify that the seat bottom is fully down.
    • The seat back is in the full upright position.
    • The upper and lower seat rails are flush at rear.
  2. Remove the seat mounting fastener covers.
    3. Fig 1: View Of Front Seat Bracket, Mounting Bolt & Nut
    GM722607Courtesy of GENERAL MOTORS CORP.
  3. Remove the 3 front seat mounting nuts.
  4. Remove the front seat mounting bolt.
  5. Disconnect the electrical harness. Unclip the harness from the seat bracket.
  6. Remove the seat from the vehicle.
  7. Place the seat on a clean, prepared surface.
scientia non olet · About LEMON Manuals