LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Front Seat Replacement - Bucket >> Installation Procedure

Installation Procedure

    Fig 1: View Of Front Seat Bracket, Mounting Bolt & Nut
    GM722607Courtesy of GENERAL MOTORS CORP.
  1. Install the seat to the vehicle.
    2. IMPORTANT: Do not move or adjust the seat adjuster release handle or the seat back until all 4 fastener attachments have been made. Do not tighten the front seat mounting bolt until the remaining 3 mounting nuts have been tightened.
  2. Install the front seat mounting bolt. Do not tighten.
    3. NOTE: Refer to FASTENER NOTICE .
  3. Install the three front seat mounting nuts on the floor studs.

    Tighten:  Tighten the front seat mounting nuts to 45 N.m (33 lb ft).

    Tighten:  Tighten the front seat mounting bolt to 45 N.m (33 lb ft).

  4. Connect the electrical harness. Clip the harness to the seat bracket.
  5. Enable SIR. Refer to SIR Disabling and Enabling .
  6. Install the seat mounting fastener covers.
scientia non olet · About LEMON Manuals