LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Front Seat Cushion Frame Replacement >> Removal Procedure

Removal Procedure

  1. Remove the 3 seat switch bezel mounting screws. Refer to Seat Switch Bezel Replacement .
    2. Fig 1: View Of Underside Of Seat Adjuster Frame & Mounting Nuts
    GM752864Courtesy of GENERAL MOTORS CORP.
  2. Remove the 4 nuts that secure the seat pan to the power seat adjuster frame.
  3. Remove the clip from the front outboard seat pan stud, if equipped. Discard the clip.
    4. Fig 2: Identifying Connectors & Harness
    GM752865Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the black electrical connector (6) from the seat back harness.
  5. Disconnect the black electrical connector (3) from the seat belt buckle.
  6. Disconnect the gray lumbar electrical connector (5), if equipped.
  7. Remove the SIR harness (2) from the harness clips (1, 4) and remove the SIR harness from the seat.
  8. Remove the seat harness from the seat pan.
  9. Remove the seat memory module, if equipped. Refer to Memory Seat Control Module Replacement .
  10. Remove the seat cushion assembly.
  11. Remove the seat cushion cover and pad from the seat frame. Refer to Seat Cushion Cover and Pad Replacement - Front .
  12. For the passenger seat, remove the passenger presence system. Refer to Inflatable Restraint Passenger Presence System Replacement - Front .
  13. Remove the wiring harness and connector clips, if you are replacing the frame.
scientia non olet · About LEMON Manuals