LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Front Seat Back Panel Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Lumbar Cables & Clips
    GM753524Courtesy of GENERAL MOTORS CORP.
  1. Remove the front bucket seat assembly from the vehicle. Refer to Front Seat Replacement - Bucket .
  2. Remove the front seat back cover and pad. Refer to Front Seat Back Cover and Cushion Pad Replacement .
  3. Remove the lumbar cables from the panel clips.
    4. Fig 2: Locating Seat Back Panel Push-Pin Side Fasteners
    GM753491Courtesy of GENERAL MOTORS CORP.
  4. Remove the 2 push-pin fasteners (1) from each side of the panel.
    5. Fig 3: Identifying Seat Back Panel Push-Pin Bottom Fastener
    GM784461Courtesy of GENERAL MOTORS CORP.
  5. Remove the push-pin fastener (1) from the bottom of the panel.
    6. Fig 4: Identifying Seat-Back Frame Panel
    GM753523Courtesy of GENERAL MOTORS CORP.
  6. Remove the panel from the top of the seat-back frame.
  7. Remove the seat-back frame.
scientia non olet · About LEMON Manuals