Tail Lamp Replacement (Isuzu)

Fig 1: View Of Tail Lamp (Isuzu)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .Preliminary Procedure: Open the liftgate in order to access the rear tail lamp screws.
1	Tail Lamp Assembly Screws (Qty: 2) Tip: Disconnect the electrical connector. Tighten: 1.9 N.m (17 lb in)
2	Locating Pins (Qty: 2)
3	Tail Lamp Lower Cover
4	Liftgate Upper Reveal Molding Tip: Ensure the tail lamp upper edge is located under the liftgate reveal molding.
5	Filler Nuts (Qty: 2) Tip: Inspect the filler nuts prior to installing the tail lamp screws.
6	Filler Retainers (Qty: 2) Tip: Ensure the retainers are secure to the body panel prior to installation of the new tail light. Transfer the circuit board to the new tail lamp. Refer to Tail Lamp Circuit Board Replacement .