LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Interior Trim And Paneling >> Repair Instructions >> Trim Panel Replacement - Rear Quarter - Right >> Removal Procedure

Removal Procedure

    Fig 1: View Of Lower Seat Belt & Rear Quarter - Right (Short Wheelbase)
    GM740429Courtesy of GENERAL MOTORS CORP.
  1. Remove the cargo shade/cover.
  2. Remove the inflator access panel.
  3. Remove the right rear quarter upper trim panel. Refer to Rear Quarter Upper Trim Panel Replacement (TrailBlazer, Envoy) .
  4. Remove the lift gate sill plate. Refer to Liftgate Door Sill Plate Replacement .
  5. Remove the right rear door sill panel. Refer to Rear Side Door Sill Plate Replacement .
  6. Remove the lower seat belt anchor bolt.
  7. Release the retaining clips that retain the trim panel to the body.
    8. Fig 2: Identifying Trim Panel - Rear Quarter - Right (TrailBlazer, Envoy, Bravada)
    GM740427Courtesy of GENERAL MOTORS CORP.
  8. Partially remove the trim panel in order to remove the inflator switch from the inflator bezel.
  9. Remove the auxiliary air outlet washer and retaining nut.
  10. Feed the auxiliary air outlet through the inflator bezel.
  11. Remove the inflator bezel from the trim panel.
  12. Disconnect the 12-volt power supply electrical connector.
  13. Remove the trim panel from the vehicle.
scientia non olet · About LEMON Manuals