LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Interior Trim And Paneling >> Repair Instructions >> Rear Window Garnish Molding Replacement >> Removal Procedure

Removal Procedure

  1. Open the liftgate.
    2. Fig 1: Locating Garnish Molding Wire Harness
    GM721365Courtesy of GENERAL MOTORS CORP.
  2. Release the clips that retain the garnish molding to the liftgate.
  3. Remove the wire harness (1) from the slot located on the garnish molding.
  4. Remove the garnish molding from the liftgate.
scientia non olet · About LEMON Manuals