LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Interior Trim And Paneling >> Repair Instructions >> Coat Hook Replacement >> Removal Procedure

Removal Procedure

  1. Access the coat hooks from the cargo area.
    2. Fig 1: Locating Retaining Bolt Through Coat Hook
    GM789090Courtesy of GENERAL MOTORS CORP.
  2. If the vehicle is equipped with diversity antennas, remove the bolt and coat hook from the roof panel.
  3. If the vehicle is NOT equipped with diversity antennas, perform the following:
    1. Loosen the bolt retaining the coat hook to the roof panel.
    2. Release the rear headliner push pins.
      3. Fig 2: Identifying Plastic & Metal Washers
      GM788415Courtesy of GENERAL MOTORS CORP.
    3. Lower the rear of the headliner far enough to access the plastic and metal washers.
    4. Hold the metal washer from rotating and remove the bolt from the coat hook.
    5. Remove the coat hook from the vehicle.
scientia non olet · About LEMON Manuals