LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Interior Trim And Paneling >> Repair Instructions >> Center Pillar Garnish Molding Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Identifying Garnish Molding (Center Pillar)
    GM740434Courtesy of GENERAL MOTORS CORP.
  1. Remove the front and rear door sill plates. Refer to Front Side Door Sill Plate Replacement  and Rear Side Door Sill Plate Replacement .
  2. Move the seat to a forward position.
  3. Partially remove the door opening weatherstrip from the door opening where it interferes with molding removal.
  4. Release the 4 retaining clips that attach the garnish molding to the center pillar.
  5. Disconnect the electrical connector from the temperature sensor, if equipped.
  6. Remove the garnish molding from the vehicle.
scientia non olet · About LEMON Manuals