LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Exterior Trim >> Repair Instructions >> Rocker Panel Rear Molding Replacement >> Removal Procedures

Removal Procedures

    Fig 1: Identifying Door Opening Screws And Push-In Retainers
    GM831869Courtesy of GENERAL MOTORS CORP.
  1. Remove rocker panel assembly. Refer to Rocker Panel Molding Replacement .
  2. Remove the door opening screws (1) from front of rocker panel rear molding.
  3. Release push-in retainers (2) using a trim removal tool.
    4. NOTE: Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.
  4. Remove the rocker panel molding from the rocker panel.
scientia non olet · About LEMON Manuals