LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Exterior Trim >> Repair Instructions >> Rocker Molding Scuff Plate Replacement - Rear >> Removal Procedure

Removal Procedure

  1. Open the rear door.
    2. Fig 1: Identifying Rear Rocker Molding Scuff Plate Retainers
    GM750775Courtesy of GENERAL MOTORS CORP.
  2. Remove the push-pin that retains the rear rocker molding scuff plate to the rocker panel.
  3. Lift upwards on the scuff plate to release the retaining tabs.
  4. Remove the scuff plate from the vehicle.
scientia non olet · About LEMON Manuals