LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Exterior Trim >> Repair Instructions >> Rear Wheel Opening Front Flare Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Wheel Opening Door Flare - Rear
    GM752102Courtesy of GENERAL MOTORS CORP.
  1. Remove the molding from the vehicle using the following procedure:
    1. Heat the wheel opening molding using aJ 25070  . Hold the heat gun approximately 152 mm (6 in) from surface.

      Apply heat using a circular motion for about 30 seconds.

      IMPORTANT: Be careful not to scratch or chip the paint.
    2. Peel the wheel opening molding from the panel surface using a flat-bladed tool.
  2. Remove all adhesive from the body panel and the back of the wheel opening molding using a 3M™ scotch brite molding adhesive remover disk 3M™ P/N 07501 or equivalent.
  3. Clean the body panel using Varnish Makers and Painters (VMP) naphtha.
scientia non olet · About LEMON Manuals