LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Exterior Trim >> Repair Instructions >> Front Fender Wheel Opening Molding Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Front Wheel Opening Molding
    GM752097Courtesy of GENERAL MOTORS CORP.
  1. Remove the 6 push-pins that secure the wheel opening molding to the fender.
  2. Remove the molding.
      IMPORTANT: Be careful not to scratch or chip the paint.
    1. Heat the wheel opening molding using aJ 25070  . Hold the heat gun approximately 152 mm (6 in) from surface.

      Apply heat using a circular motion for about 30 seconds.

    2. Peel the wheel opening molding from the panel surface using a flat-bladed tool.
  3. Remove all adhesive from the fender and the back of the molding using a 3M™ Scotch Brite molding adhesive remover disk 3M™ P/N 07501 or equivalent.
scientia non olet · About LEMON Manuals