LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management - Troubleshooting & Diagnosis >> Bosch Connectors (ECM) >> Removal Procedure

Removal Procedure

    Fig 1: View Of Bosch Connectors
    GM1709276Courtesy of GENERAL MOTORS CORP.
  1. Locate the assist lever on the top of the connector. Move the assist lever to the forward position.
    Fig 2: Identifying Assist Lever In Forward Position
    GM1709277Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the connector from the component.
    3. Fig 3: View Of Releasing Locking Tabs
    GM1709273Courtesy of GENERAL MOTORS CORP.
  3. Locate the dress cover locking tabs at the corners of the connector. Use a small flat-blade tool to release the locking tabs and remove the dress cover.
    4. Fig 4: View Of Terminal Positive Assurance (TPA) Connector
    GM1709274Courtesy of GENERAL MOTORS CORP.
  4. The terminal positive assurance (TPA) is located in the front of the connector.
    5. Fig 5: View Of Removing TPA From Connector
    GM1709278Courtesy of GENERAL MOTORS CORP.
  5. Use a small flat-blade tool to remove TPA from the connector.
    6. Fig 6: View Of Special Tools & Terminals
    GM1709275Courtesy of GENERAL MOTORS CORP.
  6. Use the J 38125-213 or the J 38125-556 (GM P/N 12093647) tool to release the terminals by inserting the tool into the terminal release cavity. See the release tool cross reference in the Reference Guide of the J-38125  to ensure that the correct release tool is used. See Special Tools .
  7. While holding the removal tool in place, gently pull the wire out of the back of the connector. Always remember never use force when pulling a terminal out of a connector.
scientia non olet · About LEMON Manuals