LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Headlights >> Lighting Systems >> Repair Instructions >> High Mounted Stop Lamp Replacement (Envoy, TrailBlazer, Rainier) >> Removal Procedure

Removal Procedure

    Fig 1: Accessing High Mount Stop Lamp Electrical Connector
    GM721363Courtesy of GENERAL MOTORS CORP.
  1. Open the liftgate.
  2. Lower the rear portion of the headliner by releasing the 2 headliner retaining pins.
  3. Disconnect the high mount stop lamp electrical connector (2).
  4. Remove the grommet (1) from the body.
    5. NOTE: Do NOT raise the liftgate while the liftgate glass is open. This can result in damage to the high-mounted stoplamp, the liftgate hinges or the liftgate glass.
  5. Close the liftgate.
  6. Open the liftgate window.
    7. Fig 2: Identifying High Mount Stoplamp Retaining Screws
    GM732876Courtesy of GENERAL MOTORS CORP.
  7. Remove the 2 screws that retain the high mount stoplamp to the lift gate window reveal molding.
  8. Remove the high mount stop lamp from the vehicle.
scientia non olet · About LEMON Manuals