LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Headlights >> Lighting Systems >> Repair Instructions >> High Mounted Stop Lamp Replacement (Envoy, TrailBlazer, Rainier) >> Installation Procedure

Installation Procedure

    Fig 1: Identifying High Mount Stoplamp Retaining Screws
    GM732876Courtesy of GENERAL MOTORS CORP.
  1. Install the high mount stop lamp to the lift gate window reveal molding, ensuring the center retaining tab is fully seated.
    2. NOTE: Refer to FASTENER NOTICE .
  2. Install the 2 screws that retain the high mount stop lamp to the lift gate window reveal molding.

    Tighten:  Tighten the 2 retaining screws to 2.5 N.m (22 lb in).

  3. Close the liftgate window.
  4. Open the liftgate.
    5. Fig 2: Accessing High Mount Stop Lamp Electrical Connector
    GM721363Courtesy of GENERAL MOTORS CORP.
  5. Install the grommet (1) to the body.
  6. Connect the high mount stoplamp electrical connector (2).
  7. Attach the rear portion of the headliner to the roof panel, by seating the 2 headliner retaining pins.
  8. Position the lift gate opening weatherstrip over the headliner.
scientia non olet · About LEMON Manuals