Hazard Lamps Always On

Step	Action	Yes	No
Schematic Reference: Exterior Lights Schematics Connector End View Reference: Lighting Systems Connector End Views
1	Did you review the Exterior Lighting Systems Description and Operation and perform the necessary inspections?	Go to Step 2	Go to Exterior Lighting Systems Description and Operation
2	Verify that the hazard lamps are always on. Do the hazard lamps operate normally?	Go to Testing for Intermittent Conditions and Poor Connections	Go to Step 3
3	Disconnect the turn/hazard flasher. Ensure that the hazard lamp switch is in the OFF position. Test for a ground signal at the hazard switch signal circuit input terminal of the hazard/turn flasher connector. Refer to Circuit Testing . Is a ground signal present?	Go to Step 4	Go to Step 5
4	Test the multifunction turn signal switch hazard switch signal circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs . Did you find and correct a condition?	Go to Step 9	Go to Step 6
5	Inspect for poor connections at the harness connector of the hazard/turn flasher. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition?	Go to Step 9	Go to Step 7
6	Inspect for poor connections at the harness connector of the multifunction turn signal switch. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition?	Go to Step 9	Go to Step 8
7	Replace the hazard/turn flasher. Refer to Hazard and Turn Signal Flasher Replacement . Did you complete the repair?	Go to Step 9	-
8	Replace the multifunction turn signal switch. Refer to Turn Signal Multifunction Switch Replacement . Did you complete the repair?	Go to Step 9	-
9	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 3