LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Transmission Mount Spacer Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Transmission Mount Spacer & Mounting Bolts
    GM1339731Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the transmission mount spacer (1).
  2. Install the transmission mount spacer mounting bolts (2).

    Tighten:  Tighten the bolts to 65 N.m (48 lb ft).

  3. Install the transmission mount. Refer to Transmission Mount Replacement (4.2L)  or Transmission Mount Replacement (5.3L) .
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals