LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Transmission Fluid Filler Tube & Seal Replacement (LL8) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Filler Tube & Seal
    GM744703Courtesy of GENERAL MOTORS CORP.
  1. Install a new seal (2) into the transmission case.
  2. Install the filler tube (1) into the seal.
  3. Remove the drain pan.
    4. Fig 2: Identifying Heat Shield Screws
    GM1697312Courtesy of GENERAL MOTORS CORP.
  4. Install the catalytic converter heat shield.
    5. NOTE: Refer to Fastener Notice .
  5. Tighten the heat shield to transmission bolts (1).

    Tighten:  Tighten the bolts to 17 N.m (13 lb ft).

    6. Fig 3: View Of Filler Tube, Nut & Stud
    GM744648Courtesy of GENERAL MOTORS CORP.
  6. Install the nut (2) securing the filler tube to the AIR stud (1).

    Tighten:  Tighten the nut to 10 N.m (89 lb in).

  7. Install the filler tube indicator.
  8. Fill the transmission to the proper level with DEXRON® VI transmission fluid. Refer to Transmission Fluid Check .
scientia non olet · About LEMON Manuals