LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Transmission Control Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Center Console Assembly
    GM1234306Courtesy of GENERAL MOTORS CORP.
  1. Remove the front floor console. Refer to Console Replacement .
    2. Fig 2: View Of Shift Control Cable & Shifter
    GM744173Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the shift lock control solenoid wiring harness.
  3. Remove the end of the range selector cable (1) from the transmission control ball stud.
  4. Remove the range selector cable (2) from the floor shift control.
    5. Fig 3: View Of Transmission Control & Bolts
    GM745783Courtesy of GENERAL MOTORS CORP.
  5. Remove the transmission control bolts.
  6. Remove the transmission control.
scientia non olet · About LEMON Manuals