LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Range Selector Lever Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Range Selector Cable & Components
    GM744174Courtesy of GENERAL MOTORS CORP.
  1. Ensure that the vehicle is in the park position.
  2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the end of the range selector cable from the transmission range selector lever ball stud (6).
  4. Remove the retainer (5) from the range selector cable.
  5. Remove the range selector cable (4) from the bracket (1).
  6. Remove the cable from the retainer (3) on the floor panel. If the vehicle is equipped with 4WD, remove the cable from the retainers located on the transfer case.
  7. Fig 2: View Of Cable Grommet At Floor Panel
    GM744168Courtesy of GENERAL MOTORS CORP.
  8. Push the cable grommet (2) up through the floor panel.
  9. Lower the vehicle.
  10. Fig 3: View Of Center Console Assembly
    GM1234306Courtesy of GENERAL MOTORS CORP.
  11. Remove the console. Refer to Console Replacement .
  12. Remove the drivers side front mat and carpet. Refer to Front Floor Panel Carpet Replacement .
  13. Fig 4: View Of Shift Control Cable & Shifter
    GM744173Courtesy of GENERAL MOTORS CORP.
  14. Remove the end of the range selector cable (1) from the floor control ball stud.
  15. Remove the range selector cable (2) from the floor shift control assembly.
  16. Remove the tape and grommet on the shift cable from the floor panel.
  17. Remove the range selector cable (3) from the vehicle.