LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Case Extension Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Case Extension, Bolts & O-Ring Seal
    GM656358Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Support the transmission with a transmission jack.
  3. Place a drain pan under the vehicle.
  4. Remove the propeller shaft. Refer to Rear Propeller Shaft Replacement .
  5. Remove the transmission mount. Refer to Transmission Mount Replacement (4.2L)  or Transmission Mount Replacement (5.3L) .
  6. Remove the case extension bolts (1).
  7. Remove the case extension (2).
  8. Remove and discard the case extension O-ring seal (3).
scientia non olet · About LEMON Manuals