LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Torque Converter Installation >> Tools Required >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: The torque converter weighs approximately 65 lbs. Personal injury may result if you lift the torque converter improperly. 
    Fig 1: View Of J 21366 Installed On Torque Converter
    GM283776Courtesy of GENERAL MOTORS CORP.
  1. Install the torque converter.
  2. Install the J 21366  . See Special Tools .
scientia non olet · About LEMON Manuals