LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Output Shaft Installation >> Tools Required >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Output Shaft
    GM588787Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: It is important to note that the input shaft may need a light tap to fully seat into position. If the input shaft is not completely engaged, the output shaft to input carrier retainer (661) will not seat.
  1. Install the output shaft (687).
    2. Fig 2: Identifying Special Tool J29837-A & Output Shaft O-Ring Seal
    GM1730029Courtesy of GENERAL MOTORS CORP.
  2. Install the J 29837-A  as shown. See Special Tools . Support the output shaft (687) with adjustable stop (1).
scientia non olet · About LEMON Manuals