LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Input Internal Gear, Reaction Shaft & Shell Installation >> Tools Required >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Input Internal Gear, Reaction Shaft & Sun Shell
    GM1730038Courtesy of GENERAL MOTORS CORP.
  1. Install the reaction sun shell (670) into the reaction sun gear.
  2. Install the thrust bearing (669) using J 36850  onto the reaction carrier shaft, tangs up, toward the shaft. See Special Tools .
  3. Install the input internal gear (664) and reaction carrier shaft (666) assembly into the sun gear shell. Index the reaction carrier shaft spline into the reaction carrier.
scientia non olet · About LEMON Manuals