LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Diagnostic Information and Procedures >> Transmission Fluid Cooler Flushing & Flow Test (J 35944-A) >> Clean-up

Transmission Fluid Cooler Flushing & Flow Test (J 35944-A): Clean-up

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the water supply hose from the J 35944-A  and bleed any remaining air pressure from the flusher tank. See Special Tools .
  2. Remove the fill cap from the J 35944-A  and return any unused flushing solution to its container. See Special Tools . Rinse the J 35944-A  with water. See Special Tools . Do not store theJ 35944-A  with flushing solution in it. See Special Tools .
  3. After every third use, clean the J 35944-A  as described in the instructions included with the tool. See Special Tools .
  4. Dispose of any waste water/solution and transmission fluid in accordance with local regulations.
scientia non olet · About LEMON Manuals