LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender 4WD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Liftgate Wiring Harness Replacement >> Removal Procedure

Removal Procedure

  1. Remove the liftgate window garnish molding. Refer to Rear Window Garnish Molding Replacement .
  2. Remove the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .
    3. Fig 1: Identifying Wiring Harness Pass Through Boot To Liftgate
    GM749976Courtesy of GENERAL MOTORS CORP.
  3. Pull the liftgate wiring harness passthrough boot away from the liftgate.
  4. Disconnect the liftgate wiring harness inline connector.
  5. Disconnect the rear washer fluid supply line.
    6. Fig 2: View Of Liftgate Window Handle Bolts And Defogger Grid Electrical Connectors
    GM698542Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the rear windshield defogger connectors (2).
    7. Fig 3: Locating Liftgate Module Electrical Connectors
    GM749979Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the electrical connectors (3) from the liftgate module.
  8. Disconnect the license plate lamp connector (1).
    9. Fig 4: Identifying License Plate Lamp Connector & Liftgate Window Latch Connector
    GM749972Courtesy of GENERAL MOTORS CORP.
  9. Disconnect the liftgate window latch connector (2).
  10. Disconnect the rear windshield wiper motor connector (1).
    11. Fig 5: Identifying Liftgate Power Lock Assembly Connectors
    GM749977Courtesy of GENERAL MOTORS CORP.
  11. Disconnect the 2 liftgate power lock assembly connectors (1,3).
    12. Fig 6: Identifying Liftgate Wiring Harness
    GM749974Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Note the routing of the liftgate wiring harness prior to removal.
  12. Use the J 36796  in order to release the wiring harness retainers.
  13. Remove the wiring harness from the liftgate.
scientia non olet · About LEMON Manuals