LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender 4WD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Hood Latch Release Cable Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Cable Grommet, Hood Release Handle & Nut
    GM740669Courtesy of GENERAL MOTORS CORP.
  1. Attach the mechanic's wire to the exterior end of the cable.
  2. Using the mechanic's wire as an aid, guide the cable underneath the sound insulation and pass the exterior portion of the cable through the cowl panel.
  3. Install the cable to the release handle (3).
  4. Seat the cable grommet (1) to the cowl panel.
  5. Install the release handle (3) to the left side kick panel.
    6. NOTE: Refer to Fastener Notice .
  6. Install the nut (2) that retains the release handle (3) to the left side kick panel.

    Tighten:  Tighten the nut to 7 N.m (62 lb in).

    7. Fig 2: View Of Hood Latch Cable To Latch
    GM742161Courtesy of GENERAL MOTORS CORP.
  7. Route the cable as previously noted, between the headlamp housing panel and the core support.
  8. Attach the cable to the retainers on the inner fender.
  9. Install the cable to the hood latch assembly.
  10. Install the hood latch. Refer to Hood Latch Replacement .
  11. Install the grille. Refer to Grille Replacement (Envoy) , Grille Replacement (Rainier) or Grille Replacement (TrailBlazer) .
  12. Install the left closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
  13. Install the left front door sill plate. Refer to Front Side Door Sill Plate Replacement .
scientia non olet · About LEMON Manuals