Windshield Washer Switch: Service and Repair

WIPER/WASHER SWITCH REPLACEMENT - REAR

REMOVAL PROCEDURE
1. Remove the instrument panel (I/P) accessory trim plate.




2. Disconnect the electrical connector from the wiper washer switch.
3. Release the wiper washer switch locking tabs.
4. Remove the switch from the trim plate.

INSTALLATION PROCEDURE




1. Position the switch to the trim plate.
2. Connect the electrical connector to the wiper washer switch.
3. Install the switch to the instrument panel trim plate, ensuring that the locking tabs are properly seated.
4. Install the I/P accessory trim plate.