Rain Sensor: Service and Repair

WINDSHIELD OUTSIDE MOISTURE SENSOR REPLACEMENT

REMOVAL PROCEDURE




1. Disconnect the electrical connector from the rain sensor (1).

IMPORTANT: The rain sensor retaining ring is permanently mounted to the windshield and is not serviceable. Damage to the windshield or the retaining ring will occur if removed.

2. Carefully pull downward on sensor (1) to release it from the retaining ring (2).
3. Remove the sensor from the vehicle.

IMPORTANT: Do not touch the surface of the sensor when it is removed from the glass.


INSTALLATION PROCEDURE
1. Clean the mounting location on the windshield using a clean lint free cloth with isopropyl alcohol.




2. Install the rain sensor (1) to the windshield.
3. Connect the electrical connector to the rain sensor (1).