Actuator: Service and Repair

Actuator Replacement - Front Drive Axle
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the engine protection shield.
3. Disconnect the electrical connector from the actuator assembly.





4. Remove the actuator assembly bolts.
5. Remove the actuator assembly.

Installation Procedure
1. Install the actuator assembly.





2. Install the actuator assembly bolts.
Tighten the bolts to 6 Nm (53 inch lbs.).

Notice: Refer to Fastener in Service Precautions.

3. Connect the electrical connector to the actuator assembly.
4. Install the engine protection shield.
5. Lower the vehicle.