Suspension Spring ( Coil / Leaf ): Service and Repair

Coil Spring Replacement

Removal Procedure
1. Raise and support the vehicle.
2. Install the rear axle support.





3. Remove the shock absorber lower mounting bolts.





4. Lower the rear axle.

Notice: Do not lower the rear axle so that the upper control arms contact the frame. Damage to the upper control arms will result.


5. Remove the rear coil springs.

Notice: Use care when handling the coil springs in order to avoid chipping or scratching the coating. Damage to the coating will result in premature failure of the coil springs.


Installation Procedure





1. Install the rear coil springs.
2. Raise the rear axle.





3. Install the shock absorber lower mounting bolts.
Tighten the shock absorber lower mounting bolts to 80 Nm (59 ft. lbs.).

Notice: Refer to Fastener Notice in Service Precautions.

4. Remove the rear axle support.
5. Lower the vehicle