Rear Axle Tie Rod Replacement

Rear Axle Tie Rod Replacement

Removal Procedure





1. Raise and support the vehicle.
2. Raise and support the rear axle at the designed D - height. Refer to Trim Height Specifications.

3. If equipped with air suspension, depressurize the air suspension system.

Important: When disconnecting the rear axle tie rod, the air suspension system must be depressurized or the body my shift during the repair.

4. Remove the rear axle tie rod to the axle mounting bolt and nut.





5. Remove the rear axle tie rod to frame mounting bolt and nut.
6. Remove the rear axle tie rod from the vehicle.

Installation Procedure





1. Install the rear axle tie rod to the vehicle.

Important: When installing the rear axle tie rod the bushings inner sleeve off set (largest gap) is towards the rear axle.

2. Install the rear axle tie rod to frame mounting bolt and nut.





3. Install the rear axle tie rod to the axle mounting bolt and nut.
Tighten the rear axle tie rod mounting bolts to 195 Nm (144 ft. lbs.).

Notice: Refer to Fastener Notice in Service Precautions.

4. Remove the rear axle support.
5. Lower the vehicle.