Power Steering Pulley Replacement

Power Steering Pulley Replacement (5.3L)

Tools Required
^ J25033-C Power Steering Pump Pulley Installer
^ J25034-C Power Steering Pump Pulley Remover

Removal Procedure





1. Remove the power steering pump.
2. Secure the power steering pump in a vise, taking care not to damage the power steering reservoir.
3. Using the J25034-C, remove the power steering pump pulley.

Installation Procedure





1. Position the power steering pump pulley to the end of the power steering pump shaft.
2. Using the J25033-C, install the power steering pump pulley to the power steering pump.





3. Install the power steering pump pulley (1) flush against the end of the power steering pump shaft (2), with an allowable variance of 0.25 mm (0.010 inch).
4. Install the power steering pump.