Ignition Lock Cylinder Case Replacement

Ignition Lock Cylinder Case Replacement
Removal Procedure

1. Disable the SIR system. Refer to SIR Disabling and Enabling in Restraint Systems.

Caution: Refer to SIR Caution in Service Precautions.

2. Remove the ignition switch.
3. Remove the turn signal cancel cam.
4. Remove the park lock cable from the lock cylinder housing.





5. Remove 3 TORX(R) screws.
6. Remove the lock cylinder housing from the steering column.

Installation Procedure





1. Install 3 TORX(R) screws into the lock cylinder housing.
Tighten the TORX(R) screws to 7 Nm (62 inch lbs.).

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the turn signal cancel cam.
3. Install the park lock cable into the lock cylinder housing.
4. Install the ignition switch.
5. Enable the SIR system. Refer to SIR Disabling and Enabling in Restraint Systems.