Blower Motor - Auxiliary (Front Auxiliary)

BLOWER MOTOR REPLACEMENT - AUXILIARY (FRONT AUXILIARY)

REMOVAL PROCEDURE
1. Remove the front floor console.




2. Disconnect the electrical connectors (4) from the blower motor-auxiliary (3).
3. Remove the air outlet duct from the blower motor-auxiliary.
4. Remove the screws (2, 5) from the blower motor-auxiliary.
5. Remove the blower motor-auxiliary (3).

INSTALLATION PROCEDURE




1. Install the blower motor-auxiliary (3).
2. Install the retaining screws (2, 5) to the blower motor-auxiliary.

Tighten the screws to 10 N.m (88 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the air outlet duct to the blower motor-auxiliary.
4. Connect the electrical connectors (4) to the blower motor-auxiliary (3).
5. Install the front floor console.