Air Outlet Duct - Floor, LH (Without RPO Code JF4)

AIR OUTLET DUCT REPLACEMENT - FLOOR, LH (WITHOUT JF4)

REMOVAL PROCEDURE




1. Remove the LH lower insulator panel.
2. Remove the push pin (2) retaining the floor air outlet duct (1) to the heater module.
3. Remove the floor duct (1).

INSTALLATION PROCEDURE




1. Install the floor air outlet duct (1) into position.
2. Install the floor air outlet duct retaining push pin (2).

Tighten the screws to 1.9 N.m (17 lb in).

NOTE: Refer to Fastener Notice.

3. Install the LH lower insulator panel.