Air Outlet Duct - Floor, LH (With RPO Code JF4)

AIR OUTLET DUCT REPLACEMENT - FLOOR, LH (WITH JF4)

REMOVAL PROCEDURE




1. Remove the instrument panel (I/P) carrier.
2. Remove the push pin (2) retaining the floor air outlet duct (1) to the heater module.
3. Remove the floor duct (1).

INSTALLATION PROCEDURE




1. Install the floor air outlet duct (1) into position.
2. Install the floor air outlet duct retaining push pin (2).

Tighten the screws to 1.9 N.m (17 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the I/P carrier.