Air Distributor Duct

AIR DISTRIBUTOR DUCT REPLACEMENT

REMOVAL PROCEDURE




1. Remove the instrument panel (I/P) assembly.
2. Remove the driver side air distributor duct screws.
3. Remove the air distributor duct (1) from the I/P.
4. Unclip the radio antenna wire from the duct
5. Remove the air temperature sensor from the duct.

INSTALLATION PROCEDURE




1. Install the air distributor duct (1) to I/P.
2. Install the retaining screws to the air distributor duct.

Tighten the screws to 1.9 N.m (17 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the air temperature sensor to the air distributor duct.
4. Clip the radio antenna wire to the duct.
5. Install the I/P assembly.