Amplifier Replacement

AMPLIFIER REPLACEMENT

REMOVAL PROCEDURE
1. Remove the upper right quarter trim panel.
2. Remove the lower right quarter trim panel.




3. Disconnect the electrical connectors from the radio speaker amplifier.
4. Remove the 4 bolts that retain the radio speaker amplifier to the body.
5. Remove the radio speaker amplifier from the body.

INSTALLATION PROCEDURE




1. Install the radio speaker amplifier to the body.
2. Install the 4 bolts that retain the radio speaker amplifier to the body.

Tighten the bolts to 10 N.m (88 lb in).

NOTE: Refer to Fastener Notice.

3. Connect the electrical connectors to the radio speaker amplifier.
4. Install the lower right quarter trim panel.
5. Install the upper right quarter trim panel.
6. Refer to Control Module References for programming and setup information.