Rear

Removal
1. Disconnect harness connector (1).
2. Remove sensor fixing bolt (2).





3. Remove speed sensor (3).

Inspection and Repair
1. Check speed sensor pole piece for presence of foreign materials; remove any dirt, etc.
2. Check the pole piece for damage, and replace speed sensor if necessary.
3. Check speed sensor cable for short or open, and replace with a new one if necessary. To check for cable short or open, bend or stretch the cable while checking for continuity.
4. Check the sensor ring for damage including tooth chipping, and if damaged, replace the axle shaft assembly.

Installation
1. Install speed sensor (3).
2. Tighten the sensor fixing bolt (2) to the specified torque.
Torque: 24 Nm (17 ft. lbs.)





3. Connect harness connector (1).