LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2002 >> Axiom Base, RWD >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Air Bag Restraint Systems >> Diagnostic Tests >> DTC 51 & 53: Deployment Event Commanded/Deployment Event Commanded With Deployment Loop Fault Or Energy Reserves Out Of Range >> Diagnostic Procedure

Diagnostic Procedure

  1. If SIR diagnostic system check has been performed, go to next step. If SIR diagnostic system check has not been performed, go to SRS DIAGNOSTIC SYSTEM CHECK .
  2. Turn ignition off. If air bags have deployed, go to next step. If air bags have not deployed, go to step  4.
  3. Replace deployed components and perform inspections as required. See POST-COLLISION INSPECTION . Clear DTC's. Go to SRS DIAGNOSTIC SYSTEM CHECK .
  4. Inspect front of vehicle and undercarriage for signs of impact. If signs of impact are found, go to next step. If signs of impact are not found, turn ignition off. Replace SDM. See SENSING & DIAGNOSTIC MODULE (SDM)  under REMOVAL & INSTALLATION. Reconnect all SRS components. Ensure all components are properly mounted. Using scan tool, clear DTC's. Go to SRS DIAGNOSTIC SYSTEM CHECK .
  5. Replace deployed components and perform inspections as required. See POST-COLLISION INSPECTION . Clear DTC's. Go to SRS DIAGNOSTIC SYSTEM CHECK .
scientia non olet · About LEMON Manuals