LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2002 >> Axiom Base, RWD >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Rear Disc Brake Pads >> Installation

Rear Disc Brake Pads: Installation

  1. Install clip. See Figure. Apply special grease (approximately 0.2 g) to both contacting surfaces of the inner shims. Wipe off extruded grease after installing. Install pad assembly with shim. Used pads must be installed to original position.
  2. Carefully use adjustable pliers to bottom the piston into the caliper bore. DO NOT pull or twist the flex hose or damage will occur. Install lock bolt and tighten the bolt to specified torque. See TORQUE SPECIFICATIONS .
  3. Install rear wheels. Pump the brake pedal several times to make sure that the pedal is firm. Check the brake fluid level in the reservoir after pumping the brakes.
scientia non olet · About LEMON Manuals