LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2002 >> Axiom Base, RWD >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Master Cylinder >> Removal

Master Cylinder: Removal

  1. Disconnect electrical connector. See Figure. Remove brake pipes and after disconnecting the brake pipe, cap or tape the openings of the brake pipe to prevent the entry of foreign matter.
  2. Remove 2 attaching nuts. Remove proportioning and bypass valve and bracket. See PROPORTIONING & BYPASS VALVE . Remove master cylinder.
  3. Check for excessive brake pedal travel, malfunction or dragging. If any of those conditions are present, check for distortion, nicks, cuts, corrosion or other abnormal conditions in the master cylinder body, fluid reservoir and O-ring. Replace parts are necessary.
scientia non olet · About LEMON Manuals