LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2002 >> Axiom Base, RWD >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Front Hub Unit Bearing (4WD Models) >> Installation

Front Hub Unit Bearing (4WD Models): Installation

  1. Install wheel pin. Place hub on a wood workbench or a block of wood approximately 6" by 6" to protect the wheel stud ends and threads. Using a hammer, install wheel stud. Be sure wheel stud is started squarely and seats completely.
  2. Install the ABS rotor sensor to the hub unit bearing. Tighten the bolts to specification. See TORQUE SPECIFICATIONS .
  3. Install the hub unit bearing to the knuckle. Tighten bolts to specification. See TORQUE SPECIFICATIONS . If there is rust on the bearing and knuckle contact surfaces, use sandpaper to remove it before installation. Take care not to push the front drive shaft and oil seal out of position.
  4. Hand tighten the front drive shaft nuts. Use NEW nuts. Install the disc rotor. See FRONT DISC BRAKE ROTOR .
  5. Tighten the front drive shaft nuts to specification. See TORQUE SPECIFICATIONS . Caulk the front drive shaft nuts. The caulking must be free of cracks.
scientia non olet · About LEMON Manuals